Electrical, lighting & electronics 20 factory variants

Monit camera 2 display activat

One characteristic of the Scania factory specification (FPC). Every vehicle leaves the factory with exactly one of the variants below — for example front door open — and SDP3 shows it in the chassis specification.

Factory variants

front door open

middle door open

door behind artic open

rear door open

any door open

direction indicat left active

direction indicat right active

bus stop brake/p brake release

bus stop brake applied

hatch left open

hatch right open

reverse gear

speed > 10km/h

wheelchair ramp extended

any door open and speed > 10km/h

steering wheel angle

any door open/wheelch ramp ext

mid door open/wheelch ramp ext

stationary+accesso m or higher

stationary v+igni on or higher

How to read it

Monit camera 2 display activat belongs to the electrical, lighting & electronics group of the Scania specification. The variant tells you what the vehicle was ordered with . The specification is fixed at production: if the vehicle was modified afterwards (a PTO added, an axle converted), the FPC list still shows the original order, while the SOPS parameters show the current configuration of each control unit. Scania SOPS Editor decodes the full specification of a SOPS file with these descriptions — including the codes themselves, which are not published here.

Related specifications

Monit cam 1 displ deact timer	7 variants	Open
Monit cam 2 displ deact timer	7 variants	Open
Monit cam 3 displ deact timer	7 variants	Open
Monit cam 4 displ deact timer	7 variants	Open
Monit cam 5 displ deact timer	7 variants	Open
Monit cam 6 displ deact timer	7 variants	Open
Monit cam 7 displ deact timer	7 variants	Open
Monit cam 8 displ deact timer	7 variants	Open