Engine & cooling 17 factory variants

Oil filling

One characteristic of the Scania factory specification (FPC). Every vehicle leaves the factory with exactly one of the variants below — for example Normal — and SDP3 shows it in the chassis specification.

Factory variants

Normal

In transmission house

In side cover

In compressor hole

In oil pan

In valve cover

Valve cover and oil pan

In engine block

Valve cover and engine block

Centrifugal oil cleaner

Front left

In engine block high

In engine block low

Rear left hand side

Rear left hand side and in valve cover.

Without

Not valid

How to read it

Oil filling belongs to the engine & cooling group of the Scania specification. The variant tells you what the vehicle was ordered with — Without means the option was not fitted at the factory . The specification is fixed at production: if the vehicle was modified afterwards (a PTO added, an axle converted), the FPC list still shows the original order, while the SOPS parameters show the current configuration of each control unit. Scania SOPS Editor decodes the full specification of a SOPS file with these descriptions — including the codes themselves, which are not published here.

Related specifications

A/C compressor VCB	2 variants	Open
A/C compressor control via ECU	2 variants	Open
ABS control valve generation	1 variants	Open
AC belt adapted compressor pulley diameter	6 variants	Open
AC pulley on engine	6 variants	Open
Accelerator control	9 variants	Open
Accelerator control interface	9 variants	Open
Accelerator ctrl man PTO mode1	2 variants	Open