Axles, suspension & steering 32 factory variants

Drive tyre rolling circumferenc

One characteristic of the Scania factory specification (FPC). Every vehicle leaves the factory with exactly one of the variants below — for example 2594 mm — and SDP3 shows it in the chassis specification.

Factory variants

2594 mm

2715 mm

2806 mm

2872 mm

2879 mm

2922 mm

2980 mm

3007 mm

3050 mm

3085 mm

3087 mm

3093 mm

3018 mm

3202 mm

3209 mm

3184 mm

3282 mm

3300 mm

3306 mm

3294 mm

3248 mm

3422 mm

3382 mm

3428 mm

3453 mm

3456 mm

3440 mm

3739 mm

3406 mm

3599 mm

3776 mm

3620 mm

How to read it

Drive tyre rolling circumferenc belongs to the axles, suspension & steering group of the Scania specification. The variant tells you what the vehicle was ordered with . The specification is fixed at production: if the vehicle was modified afterwards (a PTO added, an axle converted), the FPC list still shows the original order, while the SOPS parameters show the current configuration of each control unit. Scania SOPS Editor decodes the full specification of a SOPS file with these descriptions — including the codes themselves, which are not published here.

Related specifications

Drive mode interlock	14 variants	Open
Drive mode selector	4 variants	Open
Driven re axle 2nd disconnect	2 variants	Open
Driven rear axle lift	2 variants	Open
Driver Alert Unit system	2 variants	Open
Driver ID via coordinator	1 variants	Open
Driver area heating	4 variants	Open
Driver attention support	2 variants	Open